A&S Enhanced Trigger Guard (Benelli M1 Pre 2023 M2 M3 M4, Breda, Franchi Affinity/Intensity, Stoeger M3000))

This is a direct replacement for your OEM trigger guard. Simply remove your trigger guard from your shotgun. Strip off all the parts from the original and install them on our part.

Our part is made of high quality American milled aluminum. It is finished in a gunmetal grey hard anodize and laser marked. We do all of the machining in our shop and the metal finishing is sourced locally.

The patent-pending design has a large scallop on the front to facilitate loading. It was developed in response to the double and quad loading techniques that have been developing in the 3 gun world over the last several years. However, in testing, it was found that the feature dramatically improves single shell loading as well. It almost doubles the effective loading port area.

The A&S Benelli M4 Enhanced Trigger Guards fits Breda B12i guns, however the factory Breda trigger is slightly too long and drags on the bottom of the trigger guard. The factory Breda trigger needs between .015”-.030” removed from the circled end to function properly. Briley can perform this service while installing a trigger guard ($45 additional), or you can personally modify your trigger. If using a Briley Match Trigger the trigger will fit as normal and no additional work is needed.

USA made and counts towards 922(R) Compliance

Does not fit 12 gauge: SBE, SuperSport or any Benelli with trigger pin at the rear of the receiver. 
Does not fit 20 or 28 gauge Benelli shotguns.